Teac HS-2000 Instrukcja Użytkownika Pobierz pdf (Strona 101)

TASCAM HS-2000

101

11 – Internal settings

FILE FORMAT page

Make settings related to the file format.

Bit Length

Set the quantization bit rate for recording files using

the following buttons.

Setting buttons: 16bit (default), 24bit

Max File Size

Set the maximum size for recording files using the

following buttons.

Setting buttons: 640MB, 1GB, 2GB (default)

Pause Mode

Set whether or not to create separate files when

recording is paused using the following buttons.

Setting buttons: SPLIT (default), NO SPLIT

OPTIONS page

Make settings related to pre-recording and auto markers.

PreREC Time

Turn this function ON or OFF and set the length of pre-

recording time. (Default: OFF)

When PreREC Time is ON, signals input during

recording standby are captured and stored in the built-

in memory for the length of time set here, allowing

up to 5 seconds of the signal input before recording

is started manually to be recorded and temporarily

stored.

To set the pre–recording time, touch the knob, and

adjust the value using the DATA dial.

Setting range: 1–5 seconds (default: 2 seconds)

Auto Marker

Make settings related to auto markers.

Audio Over

•

Use this to add markers when the set audio level is

exceeded.

Turn this function ON or OFF and set the trigger level.

(Default: OFF)

To set the trigger level, touch the knob, and adjust

the value using the DATA dial.

Setting

options:

–0.20dB (default), –0.17dB, –0.13dB,

–0.10dB, –0.06dB, –0.03dB

Settings made here are reflected in the Over Level

setting on the

METER SETUP

screen.

Time Interval

•

Use this to add marks at fixed time intervals. Turn this

function ON or OFF and set the time interval. (Default:

OFF)

To set the time, touch the knob, and adjust the value

using the DATA dial.

The range of setting values is 1–10 minutes (default:

5 minutes).

Sync Unlock

•

Use this to add a mark when synchronization with

the master clock is lost. Turn this function ON or OFF.

(Default: OFF)

PRE/REC/END

•

When ON, marks are added automatically at the

pre-recording start point, recording start point and

recording end point. (Default: OFF)

NOTE

An Audio Over event occurs when the level exceeds

•

the maximum level (0 dBFS) minus the value set by the

user. (In the example above, this would be when the

level exceeds the maximum level minus 0.20 dB.)

PRE/REC/END auto markers are only added to takes

•

in take mode. They will not appear on the timeline in

timeline mode.

After an Audio Over or Sync Unlock auto marker has

•

been added, the same type of mark will not be added

again until at least 10 seconds have passed since the

last such mark was added.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 155 156

Komentarze do niniejszej Instrukcji

Brak uwag

Teac HS-2000 Instrukcja Użytkownika Strona 101

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Audio Teac HS-2000